Product features

Under construction …

Animation demo

Under construction …

Performance parameter

Specification for special controller for explosion proof pneumatic hammer

This product is a special controller for explosion-proof pneumatic hammer. Read the following instructions to remind you to use this product correctly and safely , avoid being hurt by others or yourself。

Brief introduction:

Explosion proof controller for pneumatic hammer is a controller that does not need power supply, electromagnetic valve, timer, and other control loops

(patent pending)
It can not only control a pneumatic hammer, if the pneumatic hammer equipped with a relay tube,  can control the operation of multiple
In the overall equipment installation safety. convenient, very practic

Explosion proof controller - Specification

Be careful：

1 install the hammer, please use the bolt to prevent accidental damage caused by falling
2 When moving the equipment , please turn off the hand sliding valve side of the ontroller, to prevent accidents caused by sudden start air hammer
3 after the end of the work, please be sure to close the valve , because during the continuous supply of air, air hammer will continue to blow.
4 the pressure is not stable, will make the controller Misact pressure rise - increased number of blows , pressure drop - reduced number of blows, so please install the air pressure regulating valve in front of the controller ,so that controller and air hammer work stable.
5 if you need to install (electric control) as the supply side of the controller, as a timer to use, be sure to use three way solenoid valve, in order to facilitate the discharge of residual air.

The use of air hammer piping limit:

Method of use:
The principle of the controller is to adjust the control knob to adjust the air flow, so as to change the number of strikes, the adjustment of the strike interval, according to the following order:
1 please confirm the attack surface of the flange must be solid plane. The flange of the hammer has bolted,,
2 Please install the air filter before the piping, if there is garbage or dust mixed, may lead to poor operation
3 make sure that the air pressure is 0.3~0.7mpa.
4 turn on the hand valve to confirm that the pneumatic hammer can strike normally
5 please tighten the control knob along the clockwise direction, keep in the state. No combat air hammer
6 and then set the control knob clockwise direction (1/4 circle) rotation and set the striking interval
7 set the striking interval, use the locknut to lock the control knob to prevent the loosening of control knob
8 please set the striking interval between 12 times /min~60 times /min

Recovery method for poor operation:

1 1 if the control knob counterclockwise rotation due to excessive, dysfunctional,, please pay attention to the following method:
2 the control knob clockwise to tighten in the end
3 then let the hand slide valve  move to opposite direction , discharge the residual air and reset again
4 then turn the control knob clockwise (1/4) to reset the strike interval